Juno JKI1433 User Manual download pdf (Page 8)

Installation

lf this appliance featuring magnetic door seals is

to replace an older appliance having a spring

lock (latch) on the door or lid, be sure to make

that spring lock unusable before you discard the

old appliance. This will prevent it from becoming

a death-trap for a child.

Positioning

The appliance should be installed well away from

sources of heat such as radiators, boilers, direct

sunlight etc.

Best performance is obtained with ambient

temperature between +18°C and +43°C (class T);

+18°C and +38°C (class ST); +16°C and +32°C

(class N); +10°C and +32°C (class SN).

The class of your appliance is shown on its

rating plate.

For building into kitchen units follow the special

“Building-in” instructions given.

Electrical connection

Before plugging in, ensure that the voltage and

frequency shown on the serial number plate

correspond to your domestic power supply.

Voltage can vary by ±6% of the rated voltage.

For operation with different voltages, a suitably sized

auto-transformer must be used.

Important

The appliance must be earthen.

The power supply cable plug is provided

with a contact for this purpose.

If the domestic power supply socket is not

earthed. connect the appliance to a separate

earth in compliance with current regulations,

consulting a specialist technician.

The Manufacturer declines all responsibility if

the above safety precautions are not observed.

This appliance complies with EEC directive

number, 87/308 of 2/6/87 relative to radio

interference suppression.

This appliance complies with the following

E.E.C. Directives:

- 73/23 EEC of 19.2.73 (Low Voltage Directive) and

subsequent modifications;

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent

modifications.

Door reversibility

The appliance’s door have been locked in position

for transport by means of pins on both sides.

According to the door opening direction, remove

relevant pins at the top and at the bottom.

Inner door reversal

1. Using a screwdriver release bracket (1) by

pressing on the internal spring (Fig.) and withdraw

it from its seat together with the door;

2. remove plug (2) and fit it in the hole left open on

the opposite side;

3. turn the door through 180°, remove the bracket (1)

and refit it on the opposite side.

4. Refit the door and insert the top pin and bottom

bracket (1), pushing it into place.

To ensure correct storage of food, the door is fitted

with a simple spring device which holds it in the open

position until it is properly closed.

D163

180°

PR140

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Juno JKI1433 User Manual Page 8

Comments to this Manuals

Related products and manuals for Fridge-freezers Juno JKI1433