Juno JKG7463 User Manual download pdf (Page 10)

Montageanleitung für den

integrierten Einbau

Nischenmaße

Höhe 1446 mm

Tiefe 550 mm

Breite 560 mm

Aus Gründen der Sicherheit muß eine

Mindestbelüftung gesichert sein, wie aus der

Abb.hervorgeht.

Achtung: Die Ventilations - Öffnungen müssen

immer saubergehalten werden.

Ferner ist auch am hinteren Einbauschrankteil ein

Lüftungskamin mit filgenden Massen notwendig:

Tiefe 50 mm

Breite 540 mm

50 mm

min.

200

200 cm

min.

D567

Türanschlagwechsel

Das Gerät wird mit Türanschlag von rechts

geliefert. Falls einen Türanschlag links

erfordert wird; gehen Sie wie folgt vor

bevor Sie das Gerät einbauen.

1. Obere Scharnierstift abschrauben und

Kunstoffteil entfernen.

2. Obere Tür abnehmen.

3. Mittlere Scharnier und Abdeckstöpsel

abschrauben und auf gegenüberliegende Seite

wieder anschrauben.

4. Obere Tür wieder einsetzen.

5. Oberen Scharnierstift mit den Kunstoffteil und auf

gegenüberliegende Seite wieder anmontieren.

5. Untere Scharnierstift abschrauben und

Kunstoffteil entfernen und auf gegenüberliegende

Seite wieder anmontieren.

PR01

540

CONTENTS

Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .14

Use - Cleaning the interior - Operation - Temperature regulation - Fresh food refrigeration - Freezing fresh .

food - Storage of frozen food - Ambient switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16

Use - Thawing - Ice-cube production - Movable shelves - Hints - Hints for refrigeration - Hints for freezing . .17

Use - Hints for storage of frozen food - Maintenance - Periods of no operation - Periodic cleaning . . . . .

Interior light - Defrosting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .18

Customer service and spare parts - Installation - Location - Electrical connection . . . . . . . . . . . . . . . . .19

Installation - Door reversibility . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20

Installation - Building-in instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .21

the appliance beyond repair and cause food loss.

DO NOT USE SHARP INSTRUMENTS to scrape

off frost or ice. Frost may be removed by using

the scraper provided. Under no circumstances

should solid ice be forced off the liner. Solid ice

should be allowed to thaw when defrosting the

appliance. See defrost instructions.

• Do not place carbonated or fizzy drinks in the

freezer as it creates pressure on the container,

which may cause it to explode, resulting in

damage to the appliance.

Installation

• During normal operation, the condenser and

compressor at the back of the appliance heat up

considerably. For safety reasons, minimum

ventilation must be as shown in the relevant

Figure.

Attention: keep ventilation openings clear of

obstruction.

• If the appliance is transported horizontally, it is

possible that the oil contained in the compressor

flows in the refrigerant circuit. It is advisable to

wait at least two hours before connecting the

appliance to allow the oil to flow back in the

compressor.

• There are working parts in this product which

heat up. Always ensure that there is adequate

ventilation as a failure to do this will result in

component failure and possible food loss. See

installation instructions.

• Parts which heat up should not be exposed.

Wherever possible the back of the product

should be against a wall.

• If the appliance has been transported

horizontally, it is possible that the oil contained in

the compressor ílows in the refrigerant circuit. It

is advisable to wait at least two hours before

connecting the appliance to allow tlıe oil to flow

back in the compressor.

Environment Protection

This appliance does not contain gasses which

could damage the ozone layer, in either its

refrigerant circuit or insulation materials. The

appliance shall not be discarded together with

the urban refuse and rubbish. Avoid damaging

the cooling unit, especially at the rear near the

heat exchanger. Information on your local

disposal sites may be obtained from municipal

authorities. The materials used on this appliance

marked by the symbol are recyclable.

1 2 ... 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Juno JKG7463 User Manual Page 10

Comments to this Manuals

Related products and manuals for Fridge-freezers Juno JKG7463